Hi-Bond Clear Table Top Resin - MW
Back Order
Toronto, ON
Vancouver, BC
NJ, Warehouse
FL, Warehouse
On Back Order
This item is currently on backorder. You can still place an order, but it will only ship once it’s back in stock.
Purchasing Code Required
To order this product online, please contact us with the quantity you need
and your ZIP / postal code to receive your purchasing code.
Some locations are restricted at this time.
Already have a code? Enter it below to unlock pricing and purchasing.
Hi-Bond Clear Table Top Resin
Hi-Bond Clear Table Top epoxy coating for bar tops, tabletops, plaques, etc.
- Dries to a high gloss finish.
- Mix ratio is 1 part hardener to 1 part resin.
- Used in restaurants all over the U.S.
The quart kit is a quart total volume when combined with hardener.
Hi-Bond Clear Table Top Resin Application Instructions
- Hi-Bond Table Top Epoxy should be stored at room temperature for at least 24 hours prior to usage.
- Measure exact equal parts of the resin and the hardener into a clean, dry container.
- Note: Do not adjust the ratio in an attempt to adjust the working time.
- Mix the resin and the hardener together. Mix well for two or three minutes until the materials are thoroughly mixed.
- Note: Ensure sidewalls and bottom are blended into the mix.
- Pour the mixed product onto the surface and spread using a brush. The material is self-leveling and will eventually level out any paths left by a brush.
- Allow the material to cure overnight. Depending on temperature, it may take as long as 24 hours for the material to cure.
Instructions from Hi-Bond Table Top Epoxy Preparation, Mixing and Application Guide.
WARNING: Cancer and Reproductive Harm - P65Warnings.ca.gov
