Interlux Sikkens Cetol Marine Gloss Finish - MW

Interlux Sikkens Cetol Marine Gloss Finish

Interlux Sikkens Cetol Marine Gloss with Next Wave UV-absorbing technology is a durable clear gloss protective wood finish, developed as a topcoat for Cetol Marine, Cetol Marine Light and Cetol Marine Natural Teak. Next Wave technology is the next generation of Cetol Marine from Sikkens with a unique UV-absorbing package, which is specialty resins and advanced UV absorbers that provide greater protection, durability and longevity. Cetol Marine Gloss provides a high gloss, hard wearing, UV protection and an easy to clean finish. It can be used where a gloss appearance is preferred on top of Cetol Marine, Cetol Marine Light and Cetol Marine Natural Teak. 

Cetol Marine Natural Teak Finish can be used on exterior and interior hardwood varieties such as teak, mahogany and oak. Cetol products should only be applied above the waterline. Do not use on decks.

Features:

• Durable, clear gloss finish
• Microporous, which allows wood to breathe
• Unique formula shields wood against sunlight
• Excellent weathering properties
• Flexible, allowing for the natural expansion and contraction of wood

Specifications:

• Finish: Gloss
• Coverage: 360 ft²/gal
• Number of Coats: 2-3

How to Apply Sikkens Cetol Marine Gloss Finish

If a high gloss finish is desired, Cetol Marine Gloss can be applied after the initial application of three coats of Cetol Marine, Marine Light, or Cetol Marine Natural Teak. If a brilliant high gloss finish is desired, lightly sand between coats of Cetol Marine Gloss using 220-320 grit sandpaper. In this case, Sikkens recommends the application of a third coat of Cetol Marine Gloss to compensate for the reduced layer thickness .Apply all coats within 1-2 weeks.

• Finish: Gloss
• Application Method: Brush
• Number of Coats: 2-3
• Coverage: 400 sq. ft/gal.
• Application Temp: 50°F Min. / 95°F Max.
• Thinner: Do Not Thin
• Recommended DFT: 0.6 mils dry
• Recommended WFT: 1.2 mils wet

Cetol® Marine Gloss is a gloss topcoat that can only be applied on top of a minimum of 2 coats of Cetol® Marine, Cetol® Marine Light or Cetol® Marine Natural Teak.

Application Information:

• The wood moisture content should be below 18% before application.
• Apply liberally using a long-haired bristle brush, smoothly, in the direction of the wood grain.
• Keep a wet edge to prevent lap marks and thoroughly saturate end grains where possible.
• Apply 2-3 coats of Cetol Marine Gloss.
• Always allow 24 hours drying time in between coats.
• Apply all coats within 1-2 weeks.

Click to Download Sikkens Cetol Marine Gloss Application Instructions

WARNING: Cancer and Reproductive Harm - P65Warnings.ca.gov