Interlux Fiberglass Surface Prep - MW
Interlux 601 Fiberglass Surface Prep
Interlux Fiberglass Surface Prep is a mold release agent and wax remover, which precludes the need for sanding bare fiberglass when used with Fiberglass No Sand Primer. It is also used to thoroughly clean the gelcoat and provide a key for the Fiberglass No Sand Primer to be applied. The use of Fiberglass Surface Prep to remove these contaminants is extremely important if full adhesive qualities of Fiberglass No Sand Primer are to be realized. Fiberglass Surface Prep can also be used to remove Amine Blush from clear epoxy and clean previously painted surfaces when prepping to repaint.
Features:
- Low V.O.C. fiberglass surface preparation
- Removes contamination, mold release agents, wax and amine blush
- Clean previously painted surfaces before repainting topside finishes
- Ideal for preparing inflatable boats for antifouling
***WILL SHIP GROUND ONLY TO THE CONTIGUOUS 48 STATES ONLY***
How To Apply
APPLICATION INFORMATION:
For use on Fiberglass, clear epoxy and previously painted surfaces. Apply Fiberglass Surface Prep YMA601 to a damp sponge or 3M® maroon Scotch-Brite® pad. Then scrub the surface to be cleaned using moderate pressure. Wipe off with a clean, wet cloth ensuring that no traces of Fiberglass Surface Prep YMA601 remain. Repeat until all residue is removed, changing cloths frequently. As soon as the surface is dry, it is ready to paint. Before application of the primer it is very important that all contamination has been removed. To be certain the contamination has been removed, run water over the surface, if the water beads up or separates, wipe again with Fiberglass Surface Prep YMA601. If more than 4 hours pass without overcoating wipe with a clean wet cloth and allow to dry.
WARNING: Cancer and Reproductive Harm - P65Warnings.ca.gov
